![]() However, sometimes all that’s happened is something has become lodged in the gasket somewhere. If this is the case, the door seal will need to be replaced. If the seal is worn or damaged,it can prevent the door from fully closing. The door seal or gasket runs all around the edge of the dishwasher’s door and keeps the dishwasher watertight by preventing any water or soap suds from leaking out around the door. If the door handle does prove to be broken it will need to be replaced. You should inspect the door handle for any damage and check if it is working properly. Some are connected to the door latch where others aren’t. On some models, the door will not open or close if the door handle is broken. If your dishwasher’s strike plate is made from plastic, and it becomes damaged, it will need to be replaced. Some dishwashers use a plastic strike plate which can become damaged. ![]() To solve this, all you need to do is loosen the retaining screws and adjust the strike plate to its original position. If the strike plate has become loose or misaligned, the latch won’t go in or catch firmly. The strike plate is the area that the door latch goes into. In some cases, it’s not the door latch that is misaligned, it’s the strike plate. This can be done by a competent DIYer or you can get a technician to do this for you. However, if, on inspecting the door latch you notice that it is damaged, it will need to be replaced. Then retighten the screws and check whether the door closes correctly. ![]() Then move the door latch either up or down until it lines up with the strike plate perfectly. If the door latch is misaligned you can adjust it by unscrewing the screws that hold it in position. You will need to inspect the door latch assembly and check to see if it is attached properly. If the door latch is out of alignment, it can prevent the door from closing properly and that can prevent the dishwasher from starting at all. Over time, the door latch on your dishwasher could become worn or get knocked out of alignment accidentally. This can easily be solved using a spirit level and adjusting the feet to level the appliance. If the dishwasher wasn’t levelled on installation, it could prevent the door from closing properly. The problem could even be something around the hinge area like a dropped piece of cutlery etc that is preventing the door from closing properly. ![]() If the cause is that you have overloaded the dishwasher, remove the offending item(s) and try to shut the door again. It could be something as simple as sliding the rack(s) back slightly to allow the door to fully close. You need to check that all dishes, plates and utensils are stacked in the racks correctly without any parts obstructing the door area at all. If the appliance was to operate under these conditions, it’s likely that your home would be flooded. This would prevent the dishwasher from running because the door sensor registers that the door isn’t closed. If there is anything obstructing the doorway of your dishwasher it could prevent the door from closing properly. Let’s take a closer look at each of these issues Obstructed Doorway These include Probable Cause Solution Obstructed Doorway Remove any obstructions Uneven dishwasher Adjust the feet to level the dishwasher Door Latch Misaligned Realign the door latch Misaligned Strike Plate Realign the strike plate Damaged Door Handle Repair/replace the door handle as necessary Door Seal Damaged Replace the door seal Loose Door Hinges Tighten the hinges Misshapen Door Replace the door Worn Door Springs Replace the door springs Defective Control Panel Replace the control panel There are several reasons that could prevent the door on your dishwasher from closing. Frequently Asked Questions Why Won’t The Dishwasher Door Close?.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |